Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM FXO line monitoring

Hello,

I have a CUCM 8.6 with MGCP gateway, is there a way for a live monitor of the FXO lines either from the operator phone or any solution to know if they are busy and who is using them?

Best regards.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

CUCM FXO line monitoring

Hi Marc,

You can run the debugs like debug mgcp packets/events to get the live status of the FXO lines and configure them to throw the output on a TFTP server. There is no software built to live monitor these lines.

Again if you want to know who is using these lines, probably you need to install a CCTV near the analog phone

Akhilesh Singh

3 REPLIES
New Member

CUCM FXO line monitoring

Hi Marc,

You can run the debugs like debug mgcp packets/events to get the live status of the FXO lines and configure them to throw the output on a TFTP server. There is no software built to live monitor these lines.

Again if you want to know who is using these lines, probably you need to install a CCTV near the analog phone

Akhilesh Singh

New Member

CUCM FXO line monitoring

Hehe

Ok thx :)

Bronze

CUCM FXO line monitoring

You could use also RTMT with the Cisco MGCP Gateways>FXOPortsActive monitor, but it will only show that a port is in use, not who's using it.

Gareth

268
Views
0
Helpful
3
Replies