CUCM FXO line monitoring

[Marc El Achkar]

Hello,

I have a CUCM 8.6 with MGCP gateway, is there a way for a live monitor of the FXO lines either from the operator phone or any solution to know if they are busy and who is using them?

Best regards.

[akhi3563 · Accepted solution]

Hi Marc,

You can run the debugs like debug mgcp packets/events to get the live status of the FXO lines and configure them to throw the output on a TFTP server. There is no software built to live monitor these lines.

Again if you want to know who is using these lines, probably you need to install a CCTV near the analog phone

Akhilesh Singh

[Marc El Achkar]

Hehe

Ok thx :)

[garethpeart]

You could use also RTMT with the Cisco MGCP Gateways>FXOPortsActive monitor, but it will only show that a port is in use, not who's using it.

Gareth