Not sure what I do with the workaround though. 2 live servers upgraded already. I assume I can't run the install on the bootable and then upgrade? I need the Subscriber installed as 10.5.1.11901-1 in order to join the cluster?
Brian, as I had only just upgraded, I was able to switch back to the 9.1 partition, add the new Subscriber then upgrade the extended cluster. Not ideal. My problem was the support contract had not been processed so I could not raise a TAC case at that time.
The workaround in the bug that Rob identified didn't seem much use but I think maybe I mis-understood it. Maybe TAC can supply a bootable 10.5.1.11901-1 image, in which case that gets around the issue (could always make a bootable 10.5.1.11901-1 iso using the boot sector from the 10.5.1.10000-9 but I try to keep this for the lab, haven't tried it with any 10 images yet).
I may raise a TAC case now just to see if I can get this bootable image, as if my customer lost a server, they could not rebuild.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...