Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM Power Supplies Not Redundant

hello,

i am receiving a hardware failure on one of the CUCM clusters.

event generated: hwStringMatch - hpasmxld[4060]: WARNING: System Power Supply: General Failure (Power Supply 2) hwStringMatch - hpasmxld[4060]: WARNING: System Power Supplies Not Redundant

the error fired several times, i check the enviroment power-supply it gives

ID      Status

1       Ok

2       Ok

the power is consistent/continuous and there is no power disruption not even intermitently.

so could it be a problem with the power supply iself? and how can i proove it?

regards,

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

CUCM Power Supplies Not Redundant

Swapping the power supplies will give an understanding on which module the issue is following.

But it is always better to open an TAC case and then work with TAC in fixing the issue.

Regards

Shyam

1 REPLY
New Member

CUCM Power Supplies Not Redundant

Swapping the power supplies will give an understanding on which module the issue is following.

But it is always better to open an TAC case and then work with TAC in fixing the issue.

Regards

Shyam

652
Views
0
Helpful
1
Replies
CreatePlease to create content