The phones in the two sites are registered on the Router GKA (SiteA) and GKB (SiteB). Those Routers are also CME and Gatekeeper. The RSVP reservation between the two sites works perfectly. When one of the two sites wants to make a call into the head office, the call gets forwarded to a Directory Gatekeeper and then delivered to the Gatekeeper in the head office.
The phones in the head office however are registered on a CUCM 6.0. I configured all the stuff you have to do on the CUCM: Dialpattern, Router / Gatekeeper in the head office is registered as a Media Termination Point, MRG, MRGL, the necessary location profiles are assigned to the phones and the RSVP reservation is set to "Mandatory".
When I try to make a call, the phone tells me that there is "not enough bandwidth" even though the bandwidth is set to "unlimited". I didn't figured out a way to successfully establish a RSVP reservation.
It would be nice if you could help me with a solution, but if not … I have another, simpler, question:
Is it even possible for the CUCM to make a RSVP reservation from one site to another when not all phones are registered with this CUCM?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...