Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CUCM Translation Pattern Help required

Hi All,

I am using CUCM 8.5. I have a block of number from 67030000 to 67030999. For all this numbers called via PSTN the call should land on 67030000(reception). For the numbers 67030300 and 67030400 the call should land on two different locations. The translation pattern for 67030300 and 67030400 I have created and the calls are successfully landing on the other locations. But for other numbers the translations are not happening.

Thanks & Regards,

Fawaz

20 REPLIES
Green

Re: CUCM Translation Pattern Help required

Hi,

The transdlation pattern 67030XXX

Called Party transform mask 67030000

Your other 2 patterns should be configured as full digit pattens 67030300 & 67030400

HTH

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

This is the translation pattern i have created for 67030300.

Translation Pattern: 30300

Partition:PSTN-INTERNAL

CSS:PSTN-INTERNATIONAL

Calling Party Transform Mask:67030300

Prefix Digits:9

Called Party Transform Mask:0015126021000#

Prefix Digits:9

This is the sample translation pattern I have created for other numbers.

Translation Pattern: 300XX

Partition:PSTN-INTERNAL

CSS:PSTN-INTERNATIONAL

Calling Party Transform Mask:670303XX

Prefix Digits:9

Called Party Transform Mask:30000

According to the 2nd translation pattern configuration, when i call on 67030022 the call call should land on 67030000. But instead the call is landing on 67030022.

Green

CUCM Translation Pattern Help required

Hi,

I agree with you.

Your 2nd pattern should derive 30000

I think you need to use the Dial Number Analyser and see what is going on.

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Yes  the second pattern should drive 30000. But it is not happening. The DNA test is done and below is the result for the second pattern.

  • Results Summary
  • Calling Party Information
    • Calling Party = 30022
    • Partition =
    • Device CSS =
    • Line CSS =
    • AAR Group Name =
    • AAR CSS =
  • Dialed Digits = 30066
  • Match Result = BlockThisPattern
  • Route Block Cause = Unallocated Number
  • Called Party Number =
  • Matched Pattern Information
    • Pattern =
    • Partition =
  • Pattern Type =
  • Time Zone =
  • Outside Dial Tone = NO
  • Call Flow
    • TranslationPattern :Pattern=
      • Partition =
      • Positional Match List =
      • Calling Party Number = 30022
      • PreTransform Calling Party Number =
      • PreTransform Called Party Number =
      • Calling Party Transformations
        • External Phone Number Mask = NO
        • Calling Party Mask =
        • Prefix =
        • CallingLineId Presentation =
        • CallingName Presentation =
        • Calling Party Number = 30022
      • ConnectedParty Transformations
        • ConnectedLineId Presentation =
        • ConnectedName Presentation =
      • Called Party Transformations
        • Called Party Mask =
        • Discard Digits Instruction =
        • Prefix =
        • Called Number =
  • Alternate Matches
    • Note: Information Not Available
Green

CUCM Translation Pattern Help required

Hi,

What number are you dialling ?

According to your result it was 30066

  • Dialed Digits = 30066
  • Match Result = BlockThisPattern
  • Route Block Cause = Unallocated Number

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

What ever the number may be as far as my translation pattern is 300XX, all the dialed numbers from 30000 to 30099 the call should land on 30000. Which is not happening.

Green

CUCM Translation Pattern Help required

Hi,

Can you delete the TP 300XX

Can you then search for DNs starting 300 in the route plan

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Hi,

The TP 300XX is deleted. I searched for the DNs starting 300 in the route plan. I got 47 results on that.

Regards,

Fawaz

Green

Re: CUCM Translation Pattern Help required

Hi,

Are any of these 47 other TPs that would match 30066 for example

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

No. I have only two TPs right now in CUCM. One is 30300 and 30400.

Green

CUCM Translation Pattern Help required

Hi,

Lets add a simple TP with only these settings.

Pattern 300XX

Partition INTERNAL

CSS:PSTN-INTERNATIONAL

Called Party Transform Mask:30000

Test this from a INTERNAL (Partition) phone

Then the gateway

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Hi,

That is done. The same result. The number is not getting translated. I created a TP 300XX. and called party Transform mask: 30000.

I tested internally. I called 30066, the call is landing on 30066.

I tested using pstn. Used my handphone. again the call is landing on 30066.

Regards,

Fawaz

New Member

CUCM Translation Pattern Help required

Adding the DNA test of the above said TP configuration

  • Results Summary
  • Calling Party Information
    • Calling Party = 30022
    • Partition =
    • Device CSS =
    • Line CSS = CSS-PSTN-International
    • AAR Group Name =
    • AAR CSS =
  • Dialed Digits = 30066
  • Match Result = RouteThisPattern
  • Matched Pattern Information
    • Pattern = 30066
    • Partition = PT-PSTN-Internal
    • Time Schedule =
  • Called Party Number = 30066
  • Time Zone = Etc/GMT
  • Call Classification = OnNet
  • InterDigit Timeout = NO
  • Device Override = Disabled
  • Outside Dial Tone = NO
  • Call Flow
  • TranslationPattern :Pattern=
    • Partition =
    • Positional Match List = 30066
    • Calling Party Number = 30022
    • PreTransform Calling Party Number =
    • PreTransform Called Party Number =
    • Calling Party Transformations
      • External Phone Number Mask = NO
      • Calling Party Mask =
      • Prefix =
      • CallingLineId Presentation =
      • CallingName Presentation =
      • Calling Party Number = 30022
    • ConnectedParty Transformations
      • ConnectedLineId Presentation =
      • ConnectedName Presentation =
    • Called Party Transformations
      • Called Party Mask =
      • Discard Digits Instruction =
      • Prefix =
      • Called Number =
  • Directory Number :DN= 30066
    • Partition = PT-PSTN-Internal
    • TypeCFACSSPolicy =
    • Call Classification = Unknown
    • Forwarding Information
      • Forward All : DN = VoiceMail = No CSS =
      • Forward Busy
        • Internal : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
        • External : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
      • Forward No Answer
        • Internal : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
        • External : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
      • Forward No Coverage
        • Internal : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
        • External : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
      • Forward Unregistered
        • Internal : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
        • External : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
      • CFDF : DN = 30000 VoiceMail = No CSS = CSS-PSTN-Internal
      • Pickup Group Number =
    • Device :Type= Cisco 8961
      • Device Status = Registered
      • Device Name = SEP08D09F9EB4AD
      • Ignore Presentation Indicators = Disabled
      • Logged Into Hunt Groups = Enabled
      • Alerting Name = Sivalingam Sellappan
      • Dual Mode = Disabled
      • Do Not Disturb(DND)
        • DND Status = Disabled
        • DND Option =
        • DND Incoming Call Alert =
      • Automated Alternate Routing (AAR)
        • AAR Group Name =
        • AAR Calling Search Space =
        • AAR VoiceMail Status = Disabled
        • AAR Destination Mask =
        • AAR Prefix Digits =
  • Alternate Matches
  • Partition :Name= PT-PSTN-Internal
    • Pattern
      • Pattern = 300XX
      • Pattern Type = Translation
      • TranslationPartition = [cd70125a-8e98-3209-62f2-122212116844]
      • CallManager Device Type = AccessDevice
      • PatternPrecedenceLevel = PlDefault
      • PatternRouteClass = RouteClassDefault
      • RouteNextHopByCgpn = false
Green

CUCM Translation Pattern Help required

Hi,

This is because 30066 is defined as a phone line DN

Can you test again with a spare 300XX number.

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Yes, I dialed a spare number 30012. Now it is landing on 30000.

Regards,

Fawaz

New Member

CUCM Translation Pattern Help required

I used PSTN to call 30012 and it is now landing on 30000 as required. That means all the unassigned numbers would land on 30000 and the assigned numbers will land on the respective phones. So what to do now for all the assigned DNs? I mean around 250 numbers has been assigned as of now. So is there any solution for this?

Regards,

Fawaz

Green

CUCM Translation Pattern Help required

Hi,

Is your requirement to stop individual DID/DDI from the PSTN to all your phones ?

So all DID/DDI numbers will all route to 30000

If this is the case.

If you are using H323/PRI gateways or SIP/PRI

you could invoke a PLAR on the Voice port to 30000.

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Yes my requirement is to route all the DID to the board number 30000. Except 30300 and 30400.

I am using a MGCP gateway.

Regards,

Fawaz

Green

CUCM Translation Pattern Help required

Fawaz,

This can be acheived with MGCP but it has to be carried ot on the CUCM not the IOS gateway.

1) Create a new partition like PT-PSTN-INCOME

2) Move or create new Translation patterns similar to what we know works and use the new partition.

Make sure they have a CSS that can find the destination you want like 300000 and yor 0015126021000# DN

3) Create a new CSS like CSS-PSTN-INCOME

Only put the new patition in this new CSS

4) Change the CSS of the incoming MGCP gatewat to CSS-PSTN-INCOME

Thisd new CSS & PARTITION must be private just to your PSTN gateways

Make sure you an revert if you have trouble

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
New Member

CUCM Translation Pattern Help required

Hi Alex,

Its not working. I tried it but still the call lamds on the dialed number. The number which is already assigned is not getting translated. The free numbers are getting translated. Any other way to do this?

Regards,

Fawaz

7801
Views
3
Helpful
20
Replies
CreatePlease to create content