Currently we have a customer running CUCM 8.6 with a SIP trunk to the PSTN and another trunk (ISDN-QSIG) to a Nortel Legacy PBX. The Main DID goes to an Auto Attendant on Unity Connection on the CUCM side. When Unity Connection transfer the outside caller to a Cisco IP Phone the enduser can see the ANI on their Phone displaying the outside caller number but when Unity Connection transfer the outside caller to a Nortel Phone accross the ISDN-QSIG the Nortel phone only received the ANI of the VoiceMail port that did the transfer instead of the Outside Caller phone number.
We did open a tac case to make sure that is the normal behavior for trunk to trunk transfers but I'm wondering if someone experienced the same behavior or if there is any service parameter that we can change. At the end we would like the Nortel Phones to see the outside caller information on their phones.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...