Hi, is there a config possible in CME7 where IP phone to IP phone uses G722, but calls in/out of the ISDN connection establish with G711 to IP phones? It seems once you enable G722 on CME, all VoIP legs only establish with G722 and do not dynamicaly change. ie, you need xcoder for playing the G711 MOH to ISDN or IP Phones stuck at G722. Using call manager I can controll codecs on all legs with regions and VoIP dial peers. Given that CME is on a single router I'm not sure how to configure this?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4