Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCME 8.6 Interconnection with another PBX System

Morning,Guys

Hope you are doing great.

I would like a little help here with something.

There is a customer (COMPANY “A”) which is using Cisco Call Manager Express 8.6.

On the same building, there is another internal company (COMPANY “B”)with is using a Linux based PBX system.

My question is, is it possible to integrate these two companies in terms of telephony services?

I mean…

Company “A” got its dial patterns…company “B” either.

Is it possible to add another dial-peer to this problem?

dial-peer voice 2 pots

description ConnectionToOtherCompany

destination-pattern 883..    (Example)

port 0/1/0                       ß Which will be the port? I must connect another cable to the Router, my question is if this is on the Ethernet Interfaces?

forward-digits 9

The same will be done on the other PBX system…

But my question now is regarding to the CME router, cause this is where I will step in.

NOTE:

This is only for internal calls on BOTH companies.

--
Regards
Edson Vuma       

-- Regards Edson Vuma
3 REPLIES

CUCME 8.6 Interconnection with another PBX System

Hi.

It's possibile through a SIP trunk between those two systems and configuring appropriate call routing and codec negotiation.

A possible dialpeer could be

dial-peer voice 10 voip

destination-pattern 883T

session-protocol sipv2

session-target ipv4:x.x.x.x:5060 (x.x.x.x is the ip address of the other PBX)

dtmf-relay rtp-nte

codec g711ulaw

no vad

If the other PBX requires sip authentication, you can define it under sip-ua configuration section on the CME

Before you start the integration, I suggest you to upgrade your system to the latest available IOS version

Please refer to the following link to have an idea.

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-express/91535-cme-sip-trunking-config.html

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"

Re:CUCME 8.6 Interconnection with another PBX System

Does the Linux based support SIP/h.323, if yes then check if the PBX is reachable from router by pinging it.

Then you use the Ethernet cable to connect from your router to the PBX.

Create a VoIP dial-peer pointing to the PBX with the destination ip-address for eg:

On the router

Dial-peer voice 1 VoIP
Destination-pattern 8.... >>>>>{num-plan of PBX}
Session target Ipv4: 0.0.0.0 >>>>{ip-add of PBX}
Dtmf-relay h245-alpha
Codec G711ulaw
No bad



It gig 0/0
H-323 VoIP interface
H-322 VoIP bind source add

Note: Do disable toll fraud and IP connectivity :
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-express/107626-cme-toll-fraud.html

Kindly rate the post accordingly

Regards,
Kevin

Sent from Cisco Technical Support Android App

Community Member

Re:CUCME 8.6 Interconnection with another PBX System

Thanks, guys.

Checking this ASAP.

Warm regards,

/EV

-- Regards Edson Vuma
83
Views
0
Helpful
3
Replies
CreatePlease to create content