Hoping for some help here - I have tried this multiple ways but had no success
I am trying to get CUCME 9.1 installed on a 2901 router. The router is running IOS 15.2(4)M2, and has the UCK9 feature permanently enabled. It has a 2GB flash drive.
I have downloaded CUCME 9.1 in the form of cme-152-4Mv1.rar at least 3 times onto various Windows 7 machines and either copied the TAR directly to the flash drive or put it onto a TFTP server.
The command I am using is straight out of the CME Administrator's guide " archive tar /xtract (source) (destination)
Every time I try to extract the TAR file, there is an immediate " TAR Checksum Error " message, no matter the source of the file.
I have used an MD5 calculator and validated the downloaded copies of the tar match the MD5 values on the web page. I have further used 7zip to extract a copy of the tarball onto my hard drive, and everything seems to extract fine - files are there and I can open and read the .txt.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.