cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1200
Views
0
Helpful
6
Replies

CUCME & CUE (ISM) integration (AA not functioning)

Hi,

I have a client with ISR 2901 . A cucme (Software Version  15.2(3)T1 / CME 9.0  ) with CUE (Cisco Unity Express - Administration Version 8.6.1)

is configured.

The following is cucme configuration for CUE

"Interfaces configuration"

interface ISM0/0

ip unnumbered GigabitEthernet0/1.10

service-module ip address 172.16.10.3 255.255.255.0

!Application: CUE Running on ISM

service-module ip default-gateway 172.16.10.1

!

interface GigabitEthernet0/1

description "Connected to BOM-SW1 Gig0/24"

no ip address

no ip redirects

no ip proxy-arp

ip virtual-reassembly in

duplex auto

speed auto

!

interface GigabitEthernet0/1.10

description "Voice Sub Interface"

encapsulation dot1Q 10

ip address 172.16.10.1 255.255.255.0

!

ip route 172.16.10.3 255.255.255.255 ISM0/0

Dial-Peer-Config for Unity

dial-peer voice 800 voip

description <Unity#555autoattendent>

destination-pattern 555

session target ipv4:172.16.10.3

voice-class codec 1 

dtmf-relay h245-alphanumeric

ip qos dscp cs3 signaling

no vad

!

dial-peer voice 808 voip

description (autoattendentUnity#555-sip)

destination-pattern 555

session protocol sipv2

session target ipv4:172.16.10.3

dtmf-relay sip-notify

codec g711ulaw

no vad

!

dial-peer voice 222 voip

description <ICM-CUE>

destination-pattern 554

session target ipv4:172.16.10.1

voice-class codec 1 

dtmf-relay h245-alphanumeric

ip qos dscp cs3 signaling

no vad

!

Voice-Ports Configuration

voice-port 0/1/0

trunk-group BOM-OUT

supervisory disconnect dualtone mid-call

timeouts interdigit 3

timeouts call-disconnect 1

timeouts wait-release 1

timing hookflash-out 500

connection plar opx 555

description <Ph.No. 013390>

caller-id enable

!

voice-port 0/1/1

trunk-group BOM-OUT

supervisory disconnect dualtone mid-call

cptone GB

timeouts interdigit 4

          timeouts call-disconnect 1

timeouts wait-release 1

timing hookflash-out 500

connection plar opx 555

impedance complex2

description <Ph.No. 030191>

bearer-cap Speech

caller-id enable

!

Unity Express Configuration

groupname Administrators member administrator

groupname Broadcasters privilege broadcast

username Receiptionist phonenumber "101"

restriction msg-notification create

restriction msg-notification min-digits 1

restriction msg-notification max-digits 30

restriction msg-notification dial-string preference 1 pattern * allowed

calendar biz-schedule systemschedule

closed day 1 from 00:00 to 24:00

open day 2 from 08:00 to 17:00

open day 3 from 08:00 to 17:00

open day 4 from 08:00 to 17:00

open day 5 from 08:00 to 17:00

open day 6 from 08:00 to 17:00

closed day 7 from 00:00 to 24:00

end schedule

ccn application autoattendant aa

description "autoattendant"

enabled

maxsessions 2

script "welcome.aef"

end application

ccn application ciscomwiapplication aa

description "ciscomwiapplication"

enabled

maxsessions 10

script "setmwi.aef"

parameter "CallControlGroupID" "0"

parameter "strMWI_OFF_DN" "8001"

parameter "strMWI_ON_DN" "8000"

end application

ccn application msgnotification aa

description "msgnotification"

enabled

maxsessions 10

script "msgnotify.aef"

parameter "logoutUri" "http://localhost/voicemail/vxmlscripts/mbxLogout.jsp"

parameter "DelayBeforeSendDTMF" "1"

end application

ccn application promptmgmt aa

description "promptmgmt"

enabled

maxsessions 1

script "promptmgmt.aef"

parameter "appManagementScript" ""

end application

ccn application voicemail aa

description "voicemail"

enabled

maxsessions 10

script "voicebrowser.aef"

parameter "uri" "http://localhost/voicemail/vxmlscripts/login.vxml"

parameter "logoutUri" "http://localhost/voicemail/vxmlscripts/mbxLogout.jsp"

end application

ccn engine

end engine

ccn reporting historical

database local

description "se-172-16-10-3"

end reporting

ccn subsystem email

end subsystem

ccn subsystem fax

end subsystem

ccn subsystem sip

gateway address "172.16.10.1"

end subsystem

ccn trigger http urlname msgnotifytrg

application "msgnotification"

enabled

maxsessions 2

end trigger

ccn trigger http urlname mwiapp

application "ciscomwiapplication"

enabled

maxsessions 1

end trigger

ccn trigger sip phonenumber 555

application "autoattendant"

enabled

locale "en_US"

maxsessions 2

end trigger

ccn trigger sip phonenumber 554

application "voicemail"

enabled

maxsessions 4

end trigger

service phone-authentication

end phone-authentication

service voiceview

enable

end voiceview

voicemail broadcast recording time 300

voicemail default messagesize 240

voicemail notification restriction msg-notification

voicemail operator telephone 101


!

The Call from outside is hitting on Voice Port 0/1/0 or 1 and hitting Dial-peers for CUE :"PLAR555".

But welcome message is not getting played.

Please need support for this case.

Thanks


)

)

6 Replies 6

mahmoodmkl
Level 7
Level 7

Hi.

I think u only need 1 dail-peer for AA and u r missing the below from the first dial-peer.

session protocol sipv2

Thanks

Thanks for your support.

I have included this command but still same result.

Do you think I need any more configuration on CUE!!

Thanks

Hi,

Thanks for this.

I have follow it. But issue is same.

it is not working.

Do u think we need to make any specific configuration change on CUE?

Thanks

I have found that if i call from local extension to AA # 555. the dp 800 or 808 is matched but only phone show 555 aa line busy

status.

what its mean?

The issue is resolved.

On unity i had to give command to activate license for mailbox.

This enable license for aa .

Thanks for your support.