Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCME Paging FXO - Valcom V9964

Troubleshooting a paging intergration where the Paging port will hang off hook after the initial call is disconnected and the only way to fix is do a shut/no shut on the voice-port. The voice-port configuration is

voice-port 0/1/0

supervisory disconnect dualtone pre-connect

supervisory answer dualtone sensitivity high

timing hookflash-out 50

timing sup-disconnect 750

caller-id enable

Haven't worked on many paging intergrations previously. Has anyone worked with the V9964 adapter in the past? Or have a sample Valcom FXO paging intergration to share.

Thanks!

3 REPLIES
Hall of Fame Super Gold

CUCME Paging FXO - Valcom V9964

Is the paging system calling into CME?

In that case, dualtone and pre-connect will not work for sure. You need mid-call, and the exact tone configuration.

If is CME calling into into paging, no configuration is needed, but you can update IOS to gain robustness and new features.

Community Member

CUCME Paging FXO - Valcom V9964

DaveX4285 - Did you find a workable solution for this yet?  I am having the *EXACT* same issue.  Client pages pretty heavily and every 2-3 days the port gets stuck off-hook and has to be reset.  They have been rebooting the v-9964 to clear the port.

Any advice on your fix would be appreciated.

Thanks!

Community Member

CUCME Paging FXO - Valcom V9964

I also have the same issue here.

dangquangminh@vnpro.org
CCIE#11897

dangquangminh@vnpro.org CCIE#11897 6016 Tillsdows Dr, Mississauga,ON Canada L5N4M3
985
Views
0
Helpful
3
Replies
CreatePlease to create content