Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCME / PRI Digit Outpulse Setup

All:

I am bringing a new remote office online, using a CME for the first time. When setting up dial outpulse with the carrier, I was asked how many digits did I want outpulsed.

Coming from a non-Cisco TDM/VoIP world previously, I am unsure on what Cisco as the CPE would expect - 3,4,7,9, or 10 digits.

Any help would be appreciated!

2 REPLIES

Re: CUCME / PRI Digit Outpulse Setup

Depends entirely on how many you want. All you need is a dial-peer that matches the number of digits coming in. Common practice is to use however many digits are used in your internal dial plan, because that is all you need. If you use 4-digit extension, then take 4 digits from the carrier.

New Member

Re: CUCME / PRI Digit Outpulse Setup

I figured as much - my instinct was to take 4 as they are all in a single contiguous DID block - if I had to add other NPA-NPX, i would reconfig to take more.

Thanks for the response.

489
Views
4
Helpful
2
Replies
CreatePlease login to create content