Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCME question

Hi

I have a CUCME 9.5 and I am unable to save the config from the GUI. I get the message other telnet session active.

I seem to remember this was a bug in earlier versions is this the case in 9.5.

  • IP Telephony
2 REPLIES
Blue

CUCME question

Hi

I am not sure how is this bug. As far as I know this is working as design.

-Used  command show users, find the telnet sessions.

-Do a clear line < > , in order to delete those sessions.

-Added the following commands also:

1)exec-timeout 10   ( telnet session will be disconnected after 10 min of inactivity)

2)logout-warning 60 (60 sec before automatically logging off router will send warning

message to user to save config)

-Reload the router.

Regards

Ronak Patel

Rate all helpful post by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

CUCME question

Thanks I will try what you suggest. I did find a bug for earlier version. I will let you know how it goes.

86
Views
0
Helpful
2
Replies
This widget could not be displayed.