Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCME upgrade 4.1 to 4.2

Hi all,

after upgraded CUCME from versione 4.1 to 4.2 (i tested all release from 124-11.XW1 to 124-11.XW6 ipvoice), all calls through PSTN via ISDN E1-PRI don't work fine: all calls setup go fine, but customers that are calling hears metallic voice!

Here the E1 configuration:

!

isdn switch-type primary-net5

!

!

controller E1 0/0/0

clock source internal

pri-group timeslots 1-31

!

controller E1 0/0/1

clock source internal

pri-group timeslots 1-31

!

!

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn overlap-receiving T302 5000

isdn not-end-to-end 64

isdn incoming-voice voice

isdn map address .* plan unknown type unknown

isdn send-alerting

isdn sending-complete

!

interface Serial0/0/1:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn overlap-receiving T302 5000

isdn not-end-to-end 64

isdn incoming-voice voice

isdn map address .* plan unknown type unknown

isdn send-alerting

isdn sending-complete

!

!

voice-port 0/0/0:15

input gain 10

echo-cancel coverage 32

playout-delay nominal 100

playout-delay mode fixed

cptone IT

timeouts call-disconnect infinity

music-threshold -70

!

voice-port 0/0/1:15

input gain 10

echo-cancel coverage 32

playout-delay nominal 100

playout-delay mode fixed

cptone IT

timeouts call-disconnect infinity

music-threshold -70

!

!

!

i think that with new version i'm missing some configuration command (maybe in global config?)

Any idea?

P.S.: I need to integrate CUCME with CCX5.0

thanks for support

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CUCME upgrade 4.1 to 4.2

Just metallic or very distorted and not intelligible ?

Do you have the network-participate-commands and network-clock-select commands ?

Note: you don't need:

isdn not-end-to-end 64

isdn send-alerting

and none of the settings under voice port.

3 REPLIES
Bronze

Re: CUCME upgrade 4.1 to 4.2

You may be hitting this bug:CSCsd90851

Hall of Fame Super Gold

Re: CUCME upgrade 4.1 to 4.2

No, this bug has been fixed and does not apply.

Hall of Fame Super Gold

Re: CUCME upgrade 4.1 to 4.2

Just metallic or very distorted and not intelligible ?

Do you have the network-participate-commands and network-clock-select commands ?

Note: you don't need:

isdn not-end-to-end 64

isdn send-alerting

and none of the settings under voice port.

97
Views
0
Helpful
3
Replies
CreatePlease to create content