I'm just doing simple scenario with web integrated script editor. When user presses 1 it redirects the call to hunt-group. The memebers in the group rings for about 30 seconds than the call get disconnected.
I tried to directly call the hunt-group and there isn't problem. Also through CTI Route Point forwarded to the hunt group again no problem.
It looks something from the script but I can't catch it. It should leave the call control to the CM after successful redirect which I have.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.