Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cue config for cme

Hi All

I've just upgraded a cue module (aim) on a cme 4 system to version 3 and GB language.

But now the web initialisation wizard is asking me for JTapi credentials - which I believe is only required for cue to integrate with cm.

How do i configure cue so that it integrates with the cme system that it's sat in instead?

Thanks in advance

1 REPLY
Cisco Employee

Re: cue config for cme

You have a callmanager license, not the CCME license on the module. You can load a new license from the CLI. (software install clean url <>...)

126
Views
0
Helpful
1
Replies