CUE editor Dial by extension without Terminating Key
I created an script with dial by extension (option 0 in menu). When you dial the extension(three digits: 3xx) after 0 i must dial #. I tried delete # key but when I did it Script doesn't work. The input length was changed to 3 but it did the same and no transfer unless you press # although I write in Terminating Key=none.
I reload and overwrite the script againg but I don't get it.
Re: CUE editor Dial by extension without Terminating Key
What is your Input Length? If you have Terminating Key=none, and Input Length=10 (for example), then it will only go to the Successful branch if 10 digits are entered. If you put Input Length=3, then it will collect exactly 3 digits.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.