Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUE Script doesn't understand busy tone

Hello!

I've issue at Cisco ISR 2811 CCME 4.1 with AIM-CUE (ver 3.0.3). I have script where possible to dial-by-extension. When I'm dialing by existing extension - all ok, but when dialed invalid extension number I hear silence. When IP Phone is busy - CUE can't understand that and I hear silence too.

I had test that script for invalid numbers and busy with CUCM 6.1, script worked fine.

Could you tell me plz, whats going on?

2 REPLIES

Re: CUE Script doesn't understand busy tone

This is likely due to the default transfer mode for SIP on CUE. Try the following commands on the CUE module.

cue#conf t

cue(config)#ccn subsystem sip

cue(config-sip)#transfer-mode semi-attended

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: CUE Script doesn't understand busy tone

That command I'm executed before and now,it didn't help. Any other way to resolve this issue?

141
Views
0
Helpful
2
Replies
CreatePlease login to create content