Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUE Script Problem - Call redirect to number that does not exist

We have CUE 2.3.0 running with CCME 3.3 at a branch site.

I have a problem with a AA script I am developing for this site. It's a typical Dial-by-Extension script, where it prompts the caller to enter the extension they wish to speak to if they know it.

The problem is: if a user enters an extension that doesn't exist on the CCME system, the CCME gives them a fast busy, which gets caught by the "Busy" output branch of the Call Redirect. This means that code I have for the "Invalid" output branch never gets used.

Can anyone help me?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CUE Script Problem - Call redirect to number that does not e

The call redirect is a blind transfer, so what you do in the busy branch doesnt have any effect. I would suggest that you get the digits dialed by customer, and compare it against a local user's extension using "Extension to User" step. If the extension is not valid, you can play back a prompt saying the extension is invalid. Then you can reprompt the customer to enter the extension again. You can also script it in such a way that after 3 retries, the script exits, says a goodbye prompt and hangup.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_administration_guide_chapter09186a008067a1f5.html

HTH

Sankar

PS: please remember to rate posts

3 REPLIES

Re: CUE Script Problem - Call redirect to number that does not e

The call redirect is a blind transfer, so what you do in the busy branch doesnt have any effect. I would suggest that you get the digits dialed by customer, and compare it against a local user's extension using "Extension to User" step. If the extension is not valid, you can play back a prompt saying the extension is invalid. Then you can reprompt the customer to enter the extension again. You can also script it in such a way that after 3 retries, the script exits, says a goodbye prompt and hangup.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_administration_guide_chapter09186a008067a1f5.html

HTH

Sankar

PS: please remember to rate posts

New Member

Re: CUE Script Problem - Call redirect to number that does not e

Thanks. That seems like it should work just fine. I appreciate your assistance. I will put this in place right away.

New Member

Re: CUE Script Problem - Call redirect to number that does not e

I ran into this problem and resolved it by properly setting my SIP Call Transfer Mode in CUE. I set it semi-attended.

1. config t

2. ccn subsystem sip

3. transfer-mode {attended | semi-attended | blind refer | blind bye-also]}

4. end

5. end

6. show ccn subsystem sip

attended - Transfers calls in attended mode using the REFER method. The transfer is completed when the destination extension answers the call.

semi-attended - Transfers calls in semi-attended mode using the REFER method. The transfer is completed when the destination extension is ringing.

blind refer - Transfers calls without consulting using the REFER method.

blind bye-also - Transfers calls without consulting using the BYE/ALSO method.

CiscoUnity Express uses this method if the remote end does not support REFER. This is the default value.

378
Views
25
Helpful
3
Replies