I have a deployment of CCME CUE 3.1 and 4.3, and I use the CUE with transfer-mode attended. In this case when the CUE transmitting an incoming call to a destination, the caller can not hear the ring-back tone. Also in transfer-mode phone that receives the call of CUE does not show the number of the caller.
The behavior you have seen with caller id is normal because since cue 2.4 we use "transfer-mode attended" as a default. In the previous cue 2.2.2 or earlier it uses transfer-mode blind. If you want to use the same function as previous cue version then you can add the command "transfer-mode blind bye-also" in cue configuration.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4