Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

cug outgoing calls barred (53)

Hi,

I am trying to add another extension to a remote site, I am seeing following error:

PeerAddress 238168, PeerSubAddress , DisconnectCause 35  , DisconnectText cug outgoing calls barred (53)

I have searched & only explanation I could find is "Outgoing calls barred within CUG".

Where will calls be barred ?

Here is outgoing dial-peer & debug output:

!

dial-peer voice 100 voip

preference 1

destination-pattern 23....

progress_ind setup enable 3

voice-class codec 999

voice-class h323 888

session target ipv4:192.168.250.13

dtmf-relay h245-alphanumeric

fax rate disable

ip qos dscp cs3 signaling

no vad

!


VG101#
Oct 31 10:43:02.021 EDT: ISDN Se0/0/0:23 Q931: RX <- SETUP pd = 8  callref = 0x0556
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98381
                Exclusive, Channel 1
        Calling Party Number i = 0x2181, '2174917728'
                Plan:ISDN, Type:National
        Called Party Number i = 0xA1, '2172358168'
                Plan:ISDN, Type:National
Oct 31 10:43:02.041 EDT: ISDN Se0/0/0:23 Q931: TX -> CALL_PROC pd = 8  callref = 0x8556
        Channel ID i = 0xA98381
                Exclusive, Channel 1
Oct 31 10:43:02.221 EDT: %VOIPAAA-5-VOIP_CALL_HISTORY: CallLegType 2, ConnectionId 77F6F6E030511E1947A0026994BF840, SetupTime 10:43:02.031 EDT Mon Oct 31 2011, PeerAddress 238168, PeerSubAddress , DisconnectCause 35  , DisconnectText cug outgoing calls barred (53), ConnectTime 10:43:02.211 EDT Mon Oct 31 2011, DisconnectTime 10:43:02.211 EDT Mon Oct 31 2011, CallOrigin 1, ChargedUnits 0, InfoType 2, TransmitPackets 0, TransmitBytes 0, ReceivePackets 0, ReceiveBytes 0
VG101#
VG101#
VG101#
Oct 31 10:43:02.221 EDT: %VOIPAAA-5-VOIP_FEAT_HISTORY: FEAT_VSA=fn:TWC,ft:10/31/2011 10:43:02.033,cgn:2174917728,cdn:238168,frs:0,fid:26800,fcid:77F6F6E030511E1947A0026994BF840,legID:6926,bguid:77F6F6E0030511E1947A0026994BF840
Oct 31 10:43:02.493 EDT: %VOIPAAA-5-VOIP_CALL_HISTORY: CallLegType 2, ConnectionId 77F6F6E030511E1947A0026994BF840, SetupTime 10:43:02.223 EDT Mon Oct 31 2011, PeerAddress 238168, PeerSubAddress , DisconnectCause 35  , DisconnectText cug outgoing calls barred (53), ConnectTime 10:43:02.493 EDT Mon Oct 31
VG101#
VG101#2011, DisconnectTime 10:43:02.493 EDT Mon Oct 31 2011, CallOrigin 1, ChargedUnits 0, InfoType 2, TransmitPackets 0, TransmitBytes 0, ReceivePackets 0, ReceiveBytes 0
Oct 31 10:43:02.493 EDT: %VOIPAAA-5-VOIP_FEAT_HISTORY: FEAT_VSA=fn:TWC,ft:10/31/2011 10:43:02.221,cgn:2174917728,cdn:238168,frs:0,fid:26801,fcid:77F6F6E030511E1947A0026994BF840,legID:6927,bguid:77F6F6E0030511E1947A0026994BF840
Oct 31 10:43:02.501 EDT: ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8  callref = 0x8556
        Cause i = 0x80B5 - Unknown cause value
Oct 31 10:43:02.565 EDT: ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8  callref = 0x0556
        Cause i = 0x82E4 - Invalid information element contents
Oct 31 10:43:02.569 EDT: ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x8556
Oct 31 10:43:02.569 EDT: %VOIPAAA-5-VOIP_CALL_HISTORY: CallLegType 1, ConnectionId 77F6F6E030511E1947A0026994BF840, SetupTime 10:43:02.029 EDT Mon Oct 31 2011, PeerAddress 2174917728, PeerSubAddress , DisconnectCause 35  , DisconnectText cug outgoing calls barred (53), ConnectTime 10:43:02.569 EDT Mon Oct
VG101#31 2011, DisconnectTime 10:43:02.569 EDT Mon Oct 31 2011, CallOrigin 2, ChargedUnits 0, InfoType 2, TransmitPackets 0, TransmitBytes 0, ReceivePackets 0, ReceiveBytes 0
Oct 31 10:43:02.569 EDT: %VOIPAAA-5-VOIP_FEAT_HISTORY: FEAT_VSA=fn:TWC,ft:10/31/2011 10:43:02.029,cgn:2174917728,cdn:2172358168,frs:0,fid:26799,fcid:77F6F6E030511E1947A0026994BF840,legID:6925,bguid:77F6F6E0030511E1947A0026994BF840

Thanks

Hasrat

1 ACCEPTED SOLUTION

Accepted Solutions
Green

cug outgoing calls barred (53)

Hasrat,

I was playing with MEET ME in my lab.

You can not dial direct to the MEET ME number until a conference has been started.

Put your MMET ME pattern back into the correct partition.

This partition will need to be seen in the CSS for the incoming gateway.

On one of your IP phones

Handset UP

more

MEET ME

Dial MEETME Number 238168

Phone should now display CONFERENCE

Now dial the MEET ME number from inside on another phone

You should have a 2 way call on the Conference

Now dial from OUTSIDE say a moblie to the External number  2172358168

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
8 REPLIES
Green

cug outgoing calls barred (53)

Hasrat.

Can you supply a full show run

The called number is

Called Party Number i = 0xA1, '2172358168'

Your dial peer is looking for

destination-pattern 23....

If you are droppoing thew 217 in a translation or number expansion then your dial peer is short

Try changing the dial peer to use

destination-pattern 23.....

An additional digit

HTH

Alex

Regards, Alex. Please rate useful posts.
New Member

cug outgoing calls barred (53)

Hi Alex,

Thank you for your response, here is voice translation rule, it takes rule 14, as you can see in debug output that it is changed to  238168, all other extwnions are working.

!

voice translation-rule 1

rule 1 /2172358161/ /102238161/

rule 2 /2172409131/ /238170/

rule 3 /2172409237/ /238171/

rule 4 /2172371522/ /238173/

rule 5 /2172353843/ /238174/

rule 6 /2172379214/ /238177/

rule 7 /2172317786/ /238178/

rule 8 /2172377283/ /238196/

rule 9 /2172377203/ /238195/

rule 10 /2172377284/ /238194/

rule 11 /2172372663/ /238193/

rule 12 /2172317785/ /238192/

rule 13 /2172372469/ /238189/

rule 14 /21723581\(..\)/ /2381\1/

rule 15 /^.*/ /102238161/

!

Thanks Again,

hasratr

New Member

cug outgoing calls barred (53)

Hi Alex,

Need to mention, this extension is being configured for Conference Meet Me number, in CDR, I am getting

origCause_value of 53, which has an expalanation"Service Operation Violated".

Thanks

hasrat

Green

cug outgoing calls barred (53)

Hasrat,

I think that probably explains the call failure.

I doint know which version of CUCM you are running.

From the version 7.0.1 admin book.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/7_0_1/ccmcfg/b03meet.html#wpmkr1065815

Check the security setting on the meet-me number/pattern configuration

Minimum Security Level

Choose the minimum Meet-Me conference security level for this meet-me number or pattern from the drop-down list box.

Choose Authenticated to block participants with nonsecure phones from joining the conference.

Choose Encrypted to block participants with authenticated or nonsecure phones from joining the conference.

Choose Non Secure to allow all participants to join the conference.

Note To invoke this feature, ensure you have a secure conference bridge that is configured and available. Refer to the Cisco Unified Communications Manager Security Guide for more information

Dont think there is much difference between the CUCM versions

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
New Member

cug outgoing calls barred (53)

Hi Alex,

Meet me security level is set to non secure, I removed partition still receiving same error.

thanks

hasrat

Green

cug outgoing calls barred (53)

Hasrat,

I was playing with MEET ME in my lab.

You can not dial direct to the MEET ME number until a conference has been started.

Put your MMET ME pattern back into the correct partition.

This partition will need to be seen in the CSS for the incoming gateway.

On one of your IP phones

Handset UP

more

MEET ME

Dial MEETME Number 238168

Phone should now display CONFERENCE

Now dial the MEET ME number from inside on another phone

You should have a 2 way call on the Conference

Now dial from OUTSIDE say a moblie to the External number  2172358168

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
New Member

cug outgoing calls barred (53)

Hi Alex,

Thank you for the reply, will try & update.

Regards,

hasrat

New Member

cug outgoing calls barred (53)

Hi Alex,

It works when conference is setup, thank you for all the help.

Regards,

hasrat

1227
Views
0
Helpful
8
Replies
CreatePlease to create content