Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Custom Headers

Hello!

I'm trying to figure out if any of the Cisco UC system support the ability to add a custom header. While in config mode I tried viewing the available headers "#request INVITE sip-header ?" but I didn't see the ability to create a new customer header.

Does anyone know if the UC allows you to create your own custom header, or are is the output of of the above referenced command the only SIP headers that the Cisco UC allows you to use.

Thanks in advance!

2 ACCEPTED SOLUTIONS

Accepted Solutions

Custom Headers

You can do this in a Voice GW using the SIP Profile!

On CUCM you can use the SIP Profile applied to a SIP Trunk for example.

But what kind of solotuin you are talking about? CUCM, CME...?

Regards

Hall of Fame Super Gold

Custom Headers

6 REPLIES

Custom Headers

You can do this in a Voice GW using the SIP Profile!

On CUCM you can use the SIP Profile applied to a SIP Trunk for example.

But what kind of solotuin you are talking about? CUCM, CME...?

Regards

Custom Headers

Thanks for the quick reply! It's a UC500 running CME 8.1 software. Basically, the ITSP allows a "custom tag" to be used for CDRs so that CDRs can be filtered easily. If we can create a custom tag which the UC would then send in the INVITE it would make CDR sorting/accounting much easier!

Custom Headers

*bump*

Hall of Fame Super Gold

Custom Headers

Custom Headers

Thanks for the article -- using that was able to clue into using an alternate header to achieve this.

Hall of Fame Super Gold

Re: Custom Headers

You're welcome, thank you for the nice rating and good luck!

537
Views
0
Helpful
6
Replies
CreatePlease to create content