Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

customer directory configuration plugin re-run

Hello!

Some time ago we did integration of CCM 4.2(3) with Active directory. As some changes were done on AD, at the moment I have wrong User Search Base for the users to be displayed in corporate directory. Is re-installation of the plug-in the only way to change User Search Base? If I change this, where should I keep CCMAdministrator, jtapi, dcdadmin, craadmin, in this new User Search Base or the place which is stated in CCM under "Administrative User Base"?

Thanks for reply,

best regards,

goran pilat

3 REPLIES
Cisco Employee

Re: customer directory configuration plugin re-run

yes, that's the only way as several registries and other stuff is updated when you run the plugin. the other users are usually best in the cisco OU

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: customer directory configuration plugin re-run

Hi Javalenc,

Thanks for the answer. So you are saying that my "Users Search Base" doesn't have to contain "Administrative User Base" in which CCMAdmin and other admin users are contained?

thanks,

New Member

Re: customer directory configuration plugin re-run

Hi,

You will need to make sure that CCMSysuser is in the users search base. I would put all of the CCM system users within an OU inside the users search base. Make sure their passwords are set to never expire or you will need to run the plugin again after resetting it.

D

106
Views
0
Helpful
3
Replies