Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Date and time of IP phone configured in CUCM

Hi,

I am using CUCM 7.1.3 and I have few questions. Can someone please help me?

1) Is it possible to find out when the phone (device/line) is actually configured in CUCM?

2) Can we pull the information when the phone is registered for the first time and subsequently any logs when the phone was down/up, etc?

Thanks,

Mady

  • IP Telephony
1 REPLY
Cisco Employee

Re: Date and time of IP phone configured in CUCM

1) you should be able to find out with the audit logs, time constrain from below also applies.

2) app logs and traces will have this info, but there's not going to be a "this is the 1st time this phone registers" message. They'll look exactly the same as if it was the 100th time it registers. Also, since this logs are nor permanently kept in CUCM, it all depends on how much info is stored whether you'll be able to find this for all phones or not.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
134
Views
0
Helpful
1
Replies
This widget could not be displayed.