Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DCD Directory Slow

My DC Directory is really slow no matter which phone model I am using to access it. My dcdsrvr directory is 145MB in size. While troubleshooting I found the following link :

http://cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00801eaf9d.html

Please check DCD Instability section. My CCM is 4.1(2). Is this document relevant to my problem?? Thanks in advance.

Sheeraz

1 REPLY
Hall of Fame Super Red

Re: DCD Directory Slow

Hi Sheeraz,

I do think this is relevant, but you must use the procedure listed in the proper CCM 4.1.2 doc (not from the link you sent);

Pay special attention to this step;

Installation

1. Download DCDScripts.1-0-5.exe from the Cisco CallManager Version 3.2 ( registered customers only) website.

--------------------------------------------------------------------------------

***Note*** This step is applicable only if you are running Cisco CallManager version 3.1(1) to version 3.3(2c). For Cisco CallManager 3.3(3) and later, a modified version of these scripts is installed along with Cisco CallManager. Thus, for Cisco CallManager 3.3(3) and later, do not download these scripts from CCO; instead proceed to the next installation step.

--------------------------------------------------------------------------------

2. Copy and run DCDScripts.1-0-5.exe on all the nodes in the Cisco CallManager cluster and on the CRA/CRS application servers. Accept the default settings when prompted to do so and click Unzip.

Here is the Guide for CCM 4.1.2

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00802e0e9e.html#wp1048988

Hope this helps!

Rob

131
Views
0
Helpful
1
Replies
CreatePlease to create content