Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DDI

Wer can I found information about how to configurin DID on the following scenary

Callmanager ver

H232 voice Gateway - E1 PRI

PTSN num - 2602300

Phone ext num 3xx

I want that when peopel call 2603301 it go to ext 301 and so

  • IP Telephony
5 REPLIES
Cisco Employee

Re: DDI

configure the GW as usual

on CCM significant digits set to 3

DNs using 3 digits

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: DDI

Its already done .But in wath concerning the VOice Gateway?

Before , I have a plar connection , but all the call came just to one Phone

Cisco Employee

Re: DDI

voip dial peer using the digits you expect to receive and send it to CUCM with session-target command

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Re: DDI

Hi friend,

This is a good document for Understanding Direct-Inward-Dial (DID) on IOS Voice Digital (T1/E1) Interfaces:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00801142f8.shtml#back

Hope this info helps you!

Please rate useful posts.

Best regards,

- Adrián.

New Member

Re: DDI

Hi Adrian

I am using the foolowing dial-peer

dial-peer voice 300 voip

preference 4

destination-pattern .

session target ipv4:172.19.0.253

dtmf-relay h245-alphanumeric

codec transparent

But any all the ext ( from 301 to 399 ) are receiving the call direct fom outside.How can I block some ext to not receive a call ?

110
Views
0
Helpful
5
Replies
This widget could not be displayed.