Debug isdn q931 -- can't see output

[Limitless1801]

Hi,

I just setup a new mgcp gateway which is fully register with the CCM and has all the channels in service but I can't make or receive calls.

I am trying to do some L3 debugging but after I enable the debug isdn q939 and term mon I am not getting output when I try to make a call.

I have already configured the logging to buffered 100000 7 but no success.

Does anyone know how to get this commando to work?

Thanks, RG

[paolo bevilacqua]

Check again show controller T1 and show ISDN status, the most likely cause is that L3 can't work at all.

[Limitless1801]

I have check all that and it seems to be working. I get output when I do q921 but no with q931.

Any other suggestions? Thanks, RG

[paolo bevilacqua]

What output are getting ? Not all is conducive to working status.