Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debug isdn q931 -- can't see output

Hi,

I just setup a new mgcp gateway which is fully register with the CCM and has all the channels in service but I can't make or receive calls.

I am trying to do some L3 debugging but after I enable the debug isdn q939 and term mon I am not getting output when I try to make a call.

I have already configured the logging to buffered 100000 7 but no success.

Does anyone know how to get this commando to work?

Thanks, RG

3 REPLIES
Hall of Fame Super Gold

Re: Debug isdn q931 -- can't see output

Check again show controller T1 and show ISDN status, the most likely cause is that L3 can't work at all.

New Member

Re: Debug isdn q931 -- can't see output

I have check all that and it seems to be working. I get output when I do q921 but no with q931.

Any other suggestions? Thanks, RG

Hall of Fame Super Gold

Re: Debug isdn q931 -- can't see output

What output are getting ? Not all is conducive to working status.

670
Views
0
Helpful
3
Replies