Can someone share (if available) the documentation for the debug command 'debug voip rtp' ? Facing an issue with inbound voice call from gateway. Once the user picks up the extension, its only blank and the call disconnects after a few secs. The destination is Avaya CM 3.x. There is no issue for outbound calls. The output of 'debug voip rtp' for the inbound call and outbound apparently seem to be same.
If we can interpret the debug output in a correct way, it might help troubleshooting.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.