We have two lines to make international outgoing calls to PSTN cloud.
2. SIP Trunk
In route group we have configured priority 1st via SIP trunk & 2nd via E1-PRI line for failover purpose. In case SIP trunk goes down calls will diverte through E1-PRI line.
But when we tested failover by removing SIP cable from voice gateway. Call are taking to much time to go via PRI line. There is to much delay to establish calls. Can any one help me how can i reduce this delay.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.