I've a problem in delay dialing(abt 30 sec) only to the DN 200 configured to any phone(7912 in my location)If I change any other DN to that paticular phone there is no delay.I've also changed the T320 timers no result.Although T320 timers appiled to all DNs.If any one can help.
Sounds like there is another possible match for 200 such as a DN, route pattern, or translation pattern that begins with 200. Callmanager is waiting for additional digits to find the best match. If possible, change the DN or other match to be unique. If not, you can tune down the T302 timer in CCM under Service -> Service Parameters -> Cisco Callmanager Service -> T302 Timer.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...