I just got a update from customer that after doing the above mentioned changes also still the problem persists.I can see the H323 source bind address is not configured in the GW interface.Do you suggest configuring same.Pleas let me know your inputs
Sure, go ahead and add the H323 source bind address command. When testing again, please see if you can collect the output of these two commands. Hopefully that output will show us where the delay is taking place.
- debug cch323 h225
- debug cch323 h245
The Detailed CCM traces collected from the CallManager during the same test call will give the view of the problem from the CallManager's perspective, so that might also be useful as well.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.