Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Delay when dialing only for 2 sets

CallManager 5.0

3 digit dialing in the system.

I have DN 606 and 114. I have deleted DN 6060 and 1140 (there for test). Deleted them in the unassigned DN too.

Even if I have no conflict, I have a 5 second delay when dialing those 2 DN. It is like the CM kept a trace of those two DN.

1 REPLY
Silver

Re: Delay when dialing only for 2 sets

Check if there is an existing overlapping route pattern causing the 5 second delay . Also check if there is any cpu ovehead

http://cisco.com/en/US/docs/voice_ip_comm/cucm/admin/3_0_9/p3rtrept.html

98
Views
0
Helpful
1
Replies
CreatePlease to create content