Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Destination-pattern starts with #

I've converted my customer's vg224 which was configured as MGCP to H.323 as I migrated from CM v4 to CM v7 and I'm having issues with dialing anything starts with #.

they had a paging system configured to dial #xx and it worked fine with MGCP however, as soon as you dial #, you get a busy tone from analog phone connected to VG224. I think VG224 is taking # as the end of digit delimiter.

However, from IP Phone I can dial #xx and call gets thru to one of FXO port on 2821 router.

If # is not allowed as the leading digit, will I have the same issue when this router becomes SRST router as users will dial #xx from their IP Phone?

Can someone provide me documentation that # is not allowed as leading digit? I found one for 3640 but can't verify with vg224.

Thanks

157
Views
0
Helpful
0
Replies
CreatePlease to create content