Determine handset status - when calling other extension
12.4(22)YB1/CME/CUE 7.0.2, would like to know if there is a way to obtain the offhook status of the called party when calling extension to extension. The previous PBX system that the CME replaced provided the internal caller with a "line busy" status message for the called party. So basically you knew that the other party was on a call once you started ringing, and not just forwarding their line to voicemail, or that maybe you shouldn't continue to ring the extension until the CFNA timer was triggered if you don't want to leave a voicemail.
Since there are over 50 internal extensions, using line presence (7914's configured with "m" button assignments) would be too expensive.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...