Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Device > Phones > Phone Configuration > Product Specific Configuration > I

hello,

trying to get IP Communicator 2.1 functioning over a checkpoint vpn..i have installed the getip.asp but cantt find in the phone or ccm admin where to specify its location. we get one way audio. thanks.

4 REPLIES
Cisco Employee

Re: Device > Phones > Phone Configuration > Product Specific Con

checkpoint vpn client falls under "unsupported"

clients

follow workaround at:

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/ipc/a

dmin/cadcfg.htm#wp1067624

Resolving Audio IP Address Auto-Detection Problems

If the PC on which Cisco IP Communicator is running uses an unsupported software VPN

client, audio IP address auto-detection will not work. The resulting symptom is one-way

audio.

In this case, you need to complete the following tasks:

?First, run the Cisco IP Communicator Administration Tool and select the option to enable

the HTTP access. Doing this creates a getIP.asp reflector web page. (See the "Running the

Cisco IP Communicator Administration Tool" section on page 2-14 for help.)

?Next, specify the location of the getIP.asp web page in the Cisco CallManager

Administration (Device > Phones > Phone Configuration > Product Specific

Configuration > IP Address Auto-detection URL).

By default, getIP.asp is stored here:

http:///communicatorloads/communicator/getIP.asp

If you want to change the location of the getIP.asp reflector web page, copy the getIP.asp

from the default location, place it in a new location, and enter the new URL in the Cisco

CallManager Administration (see the second bullet above). If you choose to change the

location, be aware that getIP.asp must be placed on a Microsoft IIIS Web server to work

properly for auto-detection purposes.

Tip Audio IP address settings can be viewed and configured from the Cisco IP Communicator

interface by choosing: Right-click > Preferences > Audio > Network... > Audio

IP Address.

New Member

Re: Device > Phones > Phone Configuration > Product Specific Con

where do i find this

Device > Phones > Phone Configuration > Product Specific

Configuration > IP Address Auto-detection URL

Cisco Employee

Re: Device > Phones > Phone Configuration > Product Specific Con

That is CallManager Configuration/Admin Page.

http://<>/ccmadmin

or try https

New Member

Re: Device > Phones > Phone Configuration > Product Specific Con

yes thankyou its a secure page.

can you drill into find that specific parameter?

thanks.

288
Views
0
Helpful
4
Replies