Thanks for replying. The smart host is setup in IIS. it does not allow me to put in the IP, i have to put the DNS name. I know that DNS name is ok, cause i can ping that smart host name and it replys.
Also, how do i check to see if the CSS that are assigned to the voicemail port have correct access to call out? I beleive Unity 1.x does not support Partitions / CSS.
I have attached the ports details and the smart host details so you can see what I did.
As i desperately look for the problem, i bumped into the following documenation. I helps with troubleshooting a outbound call from Unity. (I believe) well, i am going to check it out. But anymore assistance or suggestion, would really appreciate it.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.