Hi I have a new question about the configuration of the device pool in the Cisco Call Manager.
I have the Cisco Call Manager Conference Bridge registered in the CCM. I have two device pool for the phones, DevicePoolSiteA to phonesA and DevicePoolSiteB to phoneB, and the Conference Bridge is configured in the Default Pool. A Media Resource Group List was configured in the phones.
But when the Phone a call to phone b, the call is established,so the phone A call to phone c, the call is established, but when the phone a press the button confr, the conference between the phone a, b and c, is not establish and busy tone is heard.
When the phone's are configured in the default device pool the conference works without problem.
How is the best configuration of this scenario ?? I don't can configure the all phones in the same device pool.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...