Im implementing a CUCM 8.5 and a Catalyst 4500 as the core switch. My questions are the following:
1. Which is the best way to implement DHCP on this scenario?
2. Im planning to create dhcp pools on the Catalyst 4500, but how do you implement on the 4500 to get dhcp for the phones on a vlan and dhcp for computers on another vlan? Should I configure thw dhcp pools? Thanbks in advanced.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...