Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial-peer as53350 and GW 2800

I have the follow network diagram

I need the call start whit 909T going to Claro E1, but when call to 9T the call go to 2811 GW, for de PSTN E1

The configuration to as5350 and gw 2800 is:

AS5350 (172.24.10.5)

dial-peer voice 1 pots

tone ringback alert-no-PI

description ***E1 Claro***

answer-address 1700

destination-pattern 909T

direct-inward-dial

port 3/0:D

!

dial-peer voice 2 voip

answer-address 1700

description ***GW 2800***

destination-pattern 9T

voice-class codec 1

session target ipv4:10.38.172.150

dtmf-relay cisco-rtp

!

GW 2800 (10.38.172.150)

dial-peer voice 10 pots

tone ringback alert-no-PI

description ***LOCALES***

destination-pattern 9T

direct-inward-dial

port 1/0/0:15

!

When the 1700 call to 92442010 for example the calling match whit the dial-peer but the call it's incoming, and the call never go to GW2800

But when i make csim start 92442010 the call match to the dial-peer but outgoing call and call it recived but GW2800.

attach the network diagram and debug calls.

Thanks, sorry for the english.

fixie rider
1 REPLY
New Member

Re: Dial-peer as53350 and GW 2800

any idea?

fixie rider
117
Views
0
Helpful
1
Replies