05-07-2008 04:36 PM - edited 03-15-2019 10:31 AM
Ok, I have part of my problems fixed, but I cant figure out the rest.
Cisco IP Phone dials 4100
RP 4100 sends it to an h323 gateway
Dial Peer 100 voice
translation-profile incoming voip
destination-pattern ???
session protocol sipv2
session target ipv4:xx.xx.xx.xx
session transport tcp
incoming called-number ???
codec g711ulaw
What should I put in the question marks? 4... or . or?
Do I care about incoming called number?
Like wise, if the End point coming into the H323 calls into the Router looking for a CallManager phone do I use the same type of dial peer?
example:
Dial Peer 101 Voice
translation-profile incoming voip
destination-pattern .
session protocol ?????
session target ipv4:Callmanager IP?
session transport tcp
incoming called-number .
codec g711ulaw
Where do I tell the Dial Peer to go to CallManager?
Thanks much!!
05-08-2008 09:59 PM
HI TOm,
Remember that we have different rules depending the call flow
We have 2 call legs in every call
For yhe incoming dial peer we match some rules depending of different factors
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml
For outgoing dial-peer we use destination-pattern
session target ipv4:Callmanager IP?
session transport tcp
incoming called-number .
codec g711ulaw
Where do I tell the Dial Peer to go to CallManager?
You are correct!
This config is for IPIP GW SIP TO H323?
05-09-2008 08:52 AM
Thanks much for your help!!!
If the SIP end point is sending me +1415xxxxxxx
And I need to strip the + and add 9 to it, can I not do it with this?
destination-pattern +9T ???
I cant seem to get it to work. (unless my PRI is screwy)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: