07-10-2008 11:05 AM - edited 03-15-2019 11:53 AM
On an H323 gateway what dial peer do I need to configure to route an inbound 800 number that is coming in on a CAS T-1 sending the last four digits as the DNIS. Currently this T-1 is only being used for outbound traffic.
Dianna
07-10-2008 11:08 AM
Like:
dial-peer voice 1234 voip
destination-pattern 1234
session target ipv4:x.x.x.x
codeg g711u
no vad
dtmf-relay rtp-npe
Please rate post if it does!
07-10-2008 11:22 AM
This didn't work for me. When calling the number I get dead air, no ring back.
Thanks
07-10-2008 11:43 AM
can you post your full config here
07-11-2008 09:19 AM
07-11-2008 01:53 AM
Does the CM knows about the called DID?
Next step would be debugs like "cch323" with "term mon".
07-10-2008 02:01 PM
num-exp
07-11-2008 09:30 AM
Your dial-p voice 411 below specifies a 4 digit number. However you said the inbound number is 800
can you tell me the full number delievered to your gateway.
You can know this by doing a dbug isdn q.931 and place a test call to the number...
dial-peer voice 411 voip
destination-pattern [0-8]...
progress_ind setup enable 3
modem passthrough nse codec g711ulaw
session target ipv4:10.34.0.11
07-11-2008 09:52 AM
This is the message I got when I did the debug and called the number. Telco is suppose to be sending 4191 as the dnis. The whole number is 877-367-4191
Thanks,
Dianna
Jul 11 13:46:09.132: ISDN Se0/0/1:23 Q931: TX -> CONNECT pd = 8 callref = 0x807D
Jul 11 13:46:09.168: ISDN Se0/0/1:23 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x007D
Jul 11 13:46:09.168: ISDN Se0/0/1:23 **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 2 call id 0
x28CC
07-11-2008 10:04 AM
I need to see the full debug..including the part that showed the calling and called number and also the cuase code..
send the full output
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide