Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial Peer Configuration Help

On an H323 gateway what dial peer do I need to configure to route an inbound 800 number that is coming in on a CAS T-1 sending the last four digits as the DNIS. Currently this T-1 is only being used for outbound traffic.

Dianna

  • IP Telephony
9 REPLIES
Hall of Fame Super Gold

Re: Dial Peer Configuration Help

Like:

dial-peer voice 1234 voip

destination-pattern 1234

session target ipv4:x.x.x.x

codeg g711u

no vad

dtmf-relay rtp-npe

Please rate post if it does!

New Member

Re: Dial Peer Configuration Help

This didn't work for me. When calling the number I get dead air, no ring back.

Thanks

VIP Super Bronze

Re: Dial Peer Configuration Help

can you post your full config here

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: Dial Peer Configuration Help

Attached id my current config. It is configured in call manager.

Thanks for the help.

Dianna

Hall of Fame Super Gold

Re: Dial Peer Configuration Help

Does the CM knows about the called DID?

Next step would be debugs like "cch323" with "term mon".

New Member

Re: Dial Peer Configuration Help

num-exp

VIP Super Bronze

Re: Dial Peer Configuration Help

Your dial-p voice 411 below specifies a 4 digit number. However you said the inbound number is 800

can you tell me the full number delievered to your gateway.

You can know this by doing a dbug isdn q.931 and place a test call to the number...

dial-peer voice 411 voip

destination-pattern [0-8]...

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

session target ipv4:10.34.0.11

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: Dial Peer Configuration Help

This is the message I got when I did the debug and called the number. Telco is suppose to be sending 4191 as the dnis. The whole number is 877-367-4191

Thanks,

Dianna

Jul 11 13:46:09.132: ISDN Se0/0/1:23 Q931: TX -> CONNECT pd = 8 callref = 0x807D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x007D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 2 call id 0

x28CC

VIP Super Bronze

Re: Dial Peer Configuration Help

I need to see the full debug..including the part that showed the calling and called number and also the cuase code..

send the full output

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
151
Views
0
Helpful
9
Replies