Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dial-peer ignoring translation-profile at AS5400XM

Im configuring an AS5400XM and im having some problems with diak-peers ignoring Voice translation-profiles outgoing, I want to translate for example the called 5212322808 to 2808. To test Im using

#csim start 5212322808. Below is the configuration and debug.

THANKS

!

voice translation-rule 10

rule 1 /^521232\(26[4-9].\)/ /\1/

rule 2 /^521232\(28[0-5].\)/ /\1/

!

voice translation-profile CYRA

translate called 10

!

dial-peer voice 50001 voip

description =====================> VOIP TO TUCCCMSUB01

translation-profile outgoing CYRA

preference 3

service session

destination-pattern 52123228[0-5].

voice-class codec 1

session target dns:TUCCCMSUB01

dtmf-relay cisco-rtp h245-signal h245-alphanumeric

ip qos dscp cs3 signaling

no vad

!

DEBUG

*Mar 31 03:09:37.487: xrule_checking

*Mar 31 03:09:37.487: xrule_checking calling , called 5212322808

*Mar 31 03:09:37.487: xrule_checking peer_tag 50001, direction 2, protocol 0

*Mar 31 03:09:37.487: xrule_checking Return rc = -5

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: dial-peer ignoring translation-profile at AS5400XM

Yes, remember that csim will ignore translation profiles on DP, yet these configure at port or trunk level will work.

4 REPLIES
Silver

Re: dial-peer ignoring translation-profile at AS5400XM

The calls are not getting matched to any of the translation profile. could you verify the configuration details.

You can refer this configuration guide for more information on configuring Translation profiles.

http://cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml

http://cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml

New Member

Re: dial-peer ignoring translation-profile at AS5400XM

Thanks for the reply,

It was weird, becuase when I test the dial peers and the translations both work fine, but failed when I tried to make a test call using csim start, Now Im seeing that making a call from any other place (instead inside the router) it just work.

Hall of Fame Super Gold

Re: dial-peer ignoring translation-profile at AS5400XM

Yes, remember that csim will ignore translation profiles on DP, yet these configure at port or trunk level will work.

New Member

Re: dial-peer ignoring translation-profile at AS5400XM

Well, Thanks all for the support.

113
Views
0
Helpful
4
Replies