Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Dial peer issue

I am having a problem where a call comes in and it will not match my incoming called number . dial peer. I am switching them from an old fax solution to Xmedius.

Basically if I call XXX-XXX-1734 (one of their fax numbers) it will not route to the incoming dial peer I have configured. It routes to the default dial-peer 0 and I get a slow busy signal. If I call XXX-XXX-6211, it will ring to Xmedius and faxes can be made. It only happens on the 17XX numbers. I included the config and some debugs that I ran.

thanks

2 REPLIES
New Member

Re: Dial peer issue

debug voice cc inout

Bronze

Re: Dial peer issue

Put this in:

dial-peer voice 70 pots

incoming called-number .

direct-inward-dial

port 0/0/0:10

dial-peer voice 71 pots

incoming called-number .

direct-inward-dial

port 0/0/0:11

Your dial-peer voice 3 looks ok, but it doesn't specify the port.

133
Views
0
Helpful
2
Replies
CreatePlease to create content