Is it possible to match a dial-peer based simply on a source DN? So on CME if we have a location that has each DN binded to a POTS line for inbound/outbound calling, can we add a new DN and point it to a dial-peer which points to a SIP target at a remote location for all outbound calling for just that single DN?
What you can do is create a voice translation rule..and add a prefix to the called number..Then configure a new dial-peer with the new called number, you can then remove the prefix before sending the call to the ITSP
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...