Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial Peer matching on IOS

Hello,

Here is the scenario ,  I have following dial-peer

Dial-peer  voice 1000 pots

Destination-pattern 9........ ( 8 dots)

Port 0/0/0:15

Dial-peer voice 1001 pots

Destination-pattern 9T

Port 0/0/0:15

When i dial 9 1111 1111 11 then call is matched to dial-peer 1000 and send out only 1111 1111 and drop the last two 11.  Why this number does not match the dial-peer  1001 ? Is there any setting to be configured on the voice gateway in order to wait all the number to be matched and route it out on the dial-peer 1001 ?

Thanks

  • IP Telephony
2 REPLIES
Hall of Fame Super Gold

Re: Dial Peer matching on IOS

That is working as designed. As soon you enter 9 and any 8 digits, DP 1000 is matched because it's the only DP configured exactly to do that.

You have a case of overlap. If you want some numbers to be matched right away, and others by timeout, you can disambiguate the patterns using digit matches. If you can't do that (unlikely), you have to use a single DP, configured with Timeout.

Green

Dial Peer matching on IOS

Hi,

Well put by Paolo (+5)

Here is an additional link to help you

learn about dial peers

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

HTH

Alex

Regards, Alex. Please rate useful posts.
200
Views
5
Helpful
2
Replies
This widget could not be displayed.