I cannot figure out dial-peer matching. I'm trying to point a phone number at a new place. Unfortunately, the wildcard match for all of our numbers keeps matching. I don't understand why. I thought the longest match wins.
dial-peer voice 2001 voip tone ringback alert-no-PI preference 5 destination-pattern 432555.... progress_ind setup enable 3 voice-class codec 1 voice-class sip dtmf-relay force rtp-nte session protocol sipv2 session target ipv4:10.10.0.10 dtmf-relay rtp-nte ip qos dscp cs4 signaling no vad
dial-peer voice 2007 voip tone ringback alert-no-PI preference 1 destination-pattern 4325551212 progress_ind setup enable 3 voice-class codec 1 voice-class sip dtmf-relay force rtp-nte session protocol sipv2 session target ipv4:10.29.1.41 dtmf-relay rtp-nte ip qos dscp cs4 signaling no vad
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...