Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dial-peer problem from ISDN fax to CUCM via H323

We have a ISDN fax connected to a BRI port on the 2800 router. The BRI port is configured as layer 1 to 3 emulate network, so it can talk with fax.

We have configured ad couple of DP :

one (DP #10) to connect to the CUCM server via H323 session, and the other (DP#200) to bind the BRI voice port.

here is the main DP configuration lines:

dial-peer voice 10 voip

description to CUCM

destination-pattern 0T

voice-class h323 1

session target ipv4:192.168.10.10

dtmf-relay h245-alphanumeric

supplementary-service pass-through

dial-peer voice 200 pots

description Peer ISDN FAX

destination-pattern 9199

port 0/1/1

We have a analogic fax (DN 101) on CUCM and we sucesfully send faxes to the ISDN one, but not viceversa.

Attached I will include the output of the "debug voip dialpeer all"

It seem the FAX call cannot reach any output DP because of TYPE mismatch.

I think the router detect fax signal

although the voice-port is configured with a "bearer-cap Speech" option.

how we can route the outgoing fax towards CUCM H323 connection?

Many thanks

1 REPLY
New Member

Re: dial-peer problem from ISDN fax to CUCM via H323

sorry the attachment

148
Views
0
Helpful
1
Replies